3
2
4
1
NU760_1_G1-FRA.qxd 10/11/05 10:09 Page 1.19
1.19
FRONT SEATS WITH ELECTRIC CONTROL
We would advise you not
to recline the seatbacks
too far back to ensure that
the effectiveness of the
seat belts is not reduced.
Make sure that the seatback is
locked in place correctly.
No objects should be placed on
the floor (in the area in front of
the driver) as these objects could
slide under the pedal during
braking manoeuvres, thus
obstructing its use.
For safety reasons, carry
out any adjustments when
the vehicle is stationary.
Switches 1 and 3 recall the stored
seat positions: switch 1 is used to
adjust the seat base and switch 3 is
used to adjust the seatback.
For equipped vehicles, button 2 is
used for storing the chosen driving
position. It is possible to store a
driving position using the
RENAULT card.
The system operates:
- when the Hands-Free RENAULT
card is detected or, depending on
the vehicle, the remote control
RENAULT card is in the
accessories position in the card
reader;
- on vehicles fitted with button 2;
this can also be used to open the
driver’s door, with the ignition
switched off, for approximately
40 minutes.
Seat adjustments: switch 1
• To move forwards
Move it forwards.
• To move backwards
Move it backwards.
• To raise
Lift the rear of the switch.
• To lower
Lower the rear of the switch.
Seat adjustments: switch 3
To recline the seatback
Move the switch forward or
backwards.
Adjusting the lumbar support of
the driver’s seat
Move handle 4.
NU760_1_G1-ENG.qxp 27-Dec-05 18:37 Page 1.19 (Black/Process Black plate)
To Next Page
Loading...
