2
1
3
NU760_1_G1-FRA.qxd 10/11/05 10:09 Page 1.20
1.20
STORING THE DRIVER’S SEAT POSITION
It is possible to store a driving
position using the RENAULT card.
A driving position includes the
driver’s seat position and door
mirror settings.
When a driving position is stored,
the seat and door mirror settings
linked to the RENAULT card used
are automatically recalled when the
doors are unlocked and opened
using the RENAULT card.
The system operates:
- when the Hands-Free RENAULT
card is detected or, depending on
the vehicle, the remote control
RENAULT card is in the
accessories position in the card
reader;
- when the driver’s door is opened,
with the ignition off, for
approximately 40 minutes.
Driver’s seat memory procedure
With the ignition turned on, adjust
the seat using switches 1 and 3 (see
information on Front seats with
electric control in Section 1).
Press button 2 until you hear a beep:
the driving position is stored.
Repeat this procedure for each of the
RENAULT cards.
Recalling a stored position
With the vehicle stationary, briefly
press button 2.
Note: recall of the stored position is
interrupted if one of the seat
adjustment buttons is pressed
during recall.
When driving, it is possible to adjust
the driving position, but it is not
possible to recall a driving position.
Special case
Several Hands-Free cards present
in the vehicle.
In this case:
- there is no automatic recall;
- it is possible to recall by inserting
the RENAULT card in the card
reader and pressing button 2.
NU760_1_G1-ENG.qxp 27-Dec-05 18:37 Page 1.20 (Black/Process Black plate)
To Next Page
Loading...
