Renault Kangoo - Headlight Beam Adjustment

lighting:
exterior .................................................
(up to the end of the DU)
lights:
adjusting ..............................................
(up to the end of the DU)
lights:
adjustment of headlight beam height ...
(up to the end of the DU)
lights
adjustment ...........................................
(up to the end of the DU)
headlight beam adjustment .......................
(up to the end of the DU)
electric beam height adjustment ................
(up to the end of the DU)
signals and lights .......................................
(up to the end of the DU)
1.181
ENG_UD82588_3
Réglage des faisceaux (XFK - Renault)
Examples of positions for adjusting
control A according to the load
Van version Estate versions
Standard
chassis
Long
chassis
Standard
chassis
Long
chassis
(5-seater)
Long
chassis
(7-seater)
Driver alone or with
front passenger
0 0 0 0 0
All seats occupied - - 0 0 1
Driver with
passengers
and luggage (or
load) reaching
the maximum
permissible all-up
weight
- - 1 1 1
Driver without
passengers
and luggage (or
load) reaching
the maximum
permissible all-up
weight
2 2 2 2 2
The table below gives some examples. In all cases, adjust control A according to
the vehicle load so that the road can be seen and other drivers are not dazzled.
Switch A is used to adjust the height of
the headlight beams according to the
load.
With the dipped beam headlights lit,
press or lift switch A as many times as
is necessary to select the required po-
sition on the instrument panel.
Note: depending on the vehicle, when
the engine is started, the position se-
lected is displayed on the instrument
panel for approximately 30 seconds
and for 5 seconds each time switch A
is pressed.
Headlight beam adjustment
HEADLIGHT BEAM ADJUSTMENT (1/2)
A