parking distance control.............................
(current page)
operating faults ..........................................
(current page)
faults
operating faults ....................................
(current page)
2.126
ENG_UD72820_1
Aide au parking (XFK - Renault)
– select “Beep volume” to adjust the
volume of Park Assist using control 8
or 9.
Automatic deactivation of the
parking distance control
The system deactivates:
– when the vehicle speed is above ap-
proximately 6 mph (10 km/h);
– depending on the vehicle, when the
vehicle is stationary for more than
approximately three seconds and an
obstacle is detected (such as when
in a traffic jam etc.);
– when you are in N or P position;
– when an operating fault is detected.
Note: if the vehicle is fitted with a
towbar recognised by the system, only
the rear Park Assist is deactivated.
PARKING DISTANCE CONTROL (6/8)
Deactivating the parking
distance control manually
You must disable the function if:
– if towing, carrying or trailer equip-
ment that is unrecognised by the
system is present in front of the ul-
trasonic sensors;
– in the event of damage to the ultra-
sonic sensors.
Operating faults
When the system detects an operating
fault, a beep sounds for approximately
three seconds each time reverse gear
is selected and is accompanied by
the message “Check parking sensor”
shown on the instrument panel. Consult
an approved dealer.
Adjustment
– With the vehicle stopped, press the 7
switch as many times as required to
reach the “Vehicle” tab;
– press the 8 or 9 control repeatedly to
reach the “Settings” menu. Press the
switch 10 OK;
– press the 8 or 9 control repeatedly
to reach the “PARKING ASSIST”
menu. Press the switch 10 OK;
9
8
10
7
To Next Page
Loading...
