Renault RAFALE - Trip Computer

TRIP COMPUTER
2
120 - Getting to know your vehicle
General information
Trip computer and warning system
A
Dependingonthevehicle,thisin-
cludes the following functions:
– trip settings;
– information messages;
– operating fault messages (related to
the warning light);
– warning messages (connected to the
warning light).
Repeatedly press upwards/downwards
on the switch 1 to browse between
these functions.
From the instrument panel A :
a) trip settings:
– consumption since the last reset and
current fuel consumption;
– distancetravelledsincethelastre-
set;
b) service interval;
c)triplog,operatingfaultsandinfor-
mation messages.
Resetting the trip mileage recorder
andjourneyparameters(resetbut-
ton)
Withoneofthetripparametersselect-
ed as the display, press and hold the
switch 1 untilthedisplayresetstoze-
ro.
Automatic resetting of the journey
parameters
Resetting occurs automatically when
themaximumvalueofanyofthepara-
meters is exceeded.
Interpreting some of the values
displayed after resetting
Thevaluesshowingaveragefuelcon-
sumption, range and average speed
will become more stable and reliable
the further you travel after pressing the
reset button.
For the first few miles after pressing
the reset key you will notice that the
range increases as you travel. This
range takes into account the average
fuel consumption since the last time
theresetbuttonwaspressed.Howev-
er, average consumption can decrease
when:
– the vehicle stops accelerating;
– the engine reaches its operating
temperature (if the engine was cold
when the reset key was pressed);
– whendrivingfromanurbanareaon-
to the open road.