EasyManua.ls Logo

Renault RAFALE - Page 176

Renault RAFALE
406 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PARKING BRAKE
3
174 - Driving
Never leave your vehicle
without re-engaging P
position and switching
off the engine. This is
becausewhenthevehicleissta-
tionary with the engine running
and a gear engaged, the vehicle
maybegintomoveifyouacceler-
ate.
There is a risk of accidents.
Operating faults
In the event of a fault, the warning
light lightsupontheinstru-
ment panel accompanied by the
"Check parking brake" message and in
some cases the warning light .
Contact your approved Dealer straight
away.
In the event of an electronic parking
brake fault, the warning light
lights up accompanied by the "Braking
system fault" message, a beep, and in
some cases the warning light .
This means that you must stop as
soon as traffic conditions allow.
Versionswithanautomaticgear-
box
For safety reasons, automatic release
isdeactivatedwhenthedriver’sdooris
openornotshutproperlyandtheen-
gine is running (in order to prevent the
vehiclefrommovingwithoutthedri-
ver).
The "Release Parking Brake" message
appears on the instrument panel when
thedriverpressestheacceleratorped-
al.
If the "Electric System
Failure"or"Checkbat-
tery" or "WARNING:
Braking System"mes-
sageappears,youmustimmo-
bilise the vehicle by engaging the
first gear (manual gearbox), Ppo-
sition (automatic gearbox) or by
pulling the switch
3
forapproxi-
mately 10 seconds.
Iftheconditionsandtheslopere-
quire it, chock the wheels of the
vehicle.
Risk of loss of immobilisation
of the vehicle.
Call an approved dealer.
"Autohold" function
Vehicle stopped (e.g. at a red light, an
intersection, a traffic jam, etc.), the
function ensures braking force even
when the driver releases the brake
pedal.
The braking force is released as soon
as the driver accelerates sufficiently
with a gear engaged.
Activation
Press the switch
1
.
The warning light on the switch
1
comes on to confirm that the function
is activated.

Table of Contents

Related product manuals