Renault RAFALE - Page 199

ADDITIONAL DRIVING AID FUNCTIONS
3
Driving - 197
Using the switch "My Safety" 3
– To deactivate the function, if this
has been deactivated from the Custom
mode of the "My Safety" 🡺195func-
tion, press twice on the switch 3 . The
warninglightisdisplayedinyel-
low on the instrument panel.
– To reactivate the function, press
the 3 switch once. Warning light
comes on the instrument panel.
Operation
When the function is activated, the
and the left-hand and right-hand
line indicators 4 are displayed in grey
on the instrument panel.
The function is ready to alert or in
tervene ifthespeedisaboveapproxi-
mately40mph(65km/h)andifthe
warning light and the left-hand
or right-hand line indicators 5 appear
in white.
The function is in operation if theve-
hicle
– approachesaroadsidewithoutacti-
vating direction indicators;
– crossesacontinuouslinewithoutac-
tivating the indicator lights;
– crossesabrokenlinewithoutacti-
vating the direction indicators, if the
"operationonbrokenline"settingisse-
lected.
In these cases:
– the function triggers an action on the
vehicle's steering system to correct the
vehicle trajectory;
– the warninglightandtheindi-
cator 4 on the side of the breached
linechangestoyellowontheinstru-
ment panel.
If the corrective action on the steering
system is not sufficient, the
warning light and the indicator 4 on
the side of the breached line change to
redontheinstrumentpanel,accompa-
nied by a vibration on the steering
wheel.
When the "Operation on broken line"
setting is not selected, the function
sounds the alarm ifthevehiclecross-
es a broken line without activating the
indicatorlights,andthereisnoroad-
side close enough to the line.
Inthiscase,thefunctionwarnsthedri-
ver:
– by a vibration in the steering wheel;
and