Renault RAFALE - Page 225

ADDITIONAL DRIVING AID FUNCTIONS
3
Driving - 223
With the vehicle stationary, to access
thefunctionsettingsfromthemultime-
dia screen 3 , refer to the multimedia
instructions:
"Warning anticipation": adjust the alert
sensitivity level. To do this select:
– «Late»;
– «Standard»;
– «Early».
Pleaserefertothemultimediainstruc-
tions for more information.
Temporarily not available
If the system detects a temporary fault,
the warning light appears on the
instrument panel.
The possible causes are:
– the system is temporarily blinded
(glare from the sun, dipped beam
headlights, bad weather conditions
etc.). The system will be operational
again when visibility conditions are
better;
– the system is temporarily interrupted
(e.g. the windscreen, front or rear
bumper or logo is obscured by dirt,
mud, snow, condensation, etc.) In this
case, park the vehicle and switch off
the engine. Clean the windscreen, the
front bumper or the logo. The next time
the engine is started, after around five
or ten minutes of driving, the warning
light and the message disappear. If
this is not the case, this may arise from
another cause; contact an approved
dealer.
Operating faults
If the system detects a temporary fault,
the warning light appears on the
instrument panel. Consult an approved
dealer.