23
www.renishaw.com
RCLC mounting
Suitable for:
• RCLC glass spar scale, any length
Required parts:
• RCLC scale (see 'RCLC installation drawing' on page 22)
• RGG-2 two part epoxy adhesive (A-9531-0342)
• Appropriate cleaning solvents (see 'Storage and handling' on page 8)
Optional parts:
• Renishaw scale wipes (A-9523-4040)
• Lint-free cloth
1. Thoroughly clean and degrease the substrate using recommended solvents
(see 'Storage and handling' on page 8). Allow substrate to dry before
applying scale.
2.
Remove backing paper from scale.
4. Locate scale against dowels or ledge and rotate down onto the substrate.
1
1
If dowels or ledge are permanent, their maximum height above substrate is 1.2mm.
3. Ensure correct orientation of the scale for chosen reference mark location (middle or end of scale)
andreadhead orientation. See 'RCLC installation drawing' on page 22 for details.
Location ledge
or
Support dowels
To Next Page
Loading...
