6
ATOM linear encoder system
Compliance
Federal Code Of Regulation (CFR) FCC Part 15 –
RADIOFREQUENCYDEVICES
47 CFR Section 15.19
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1)This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
47 CFR Section 15.21
The user is cautioned that any changes or modications not expressly approved by Renishaw plc
or authorised representative could void the user’s authority to operate the equipment.
47 CFR Section 15.105
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
47 CFR Section 15.27
This unit was tested with shielded cables on the peripheral devices. Shielded cables must be
used with the unit to ensure compliance.
Legal notices
Patents
Features of Renishaw’s encoder systems and similar products are the subjects of the following
patents and patent applications:
CN1314511C EP1469969 JP5002559 US8466943
CN101300463B EP1946048 JP5017275 US7624513B2
CN101310165B EP1957943 US7839296 WO2014096764
Terms and conditions and warranty
Unless you and Renishaw have agreed and signed a separate written agreement, the equipment
and /or software are sold subject to the Renishaw Standard Terms and Conditions supplied with
such equipment and /or software, or available on request from your local Renishaw ofce.
Renishaw warrants its equipment and software for a limited period (as set out in the Standard
Terms and Conditions), provided that they are installed and used exactly as dened in associated
Renishaw documentation. You should consult these Standard Terms and Conditions to nd out
the full details of yourwarranty.
Equipment and /or software purchased by you from a third-party supplier is subject to separate
termsand conditions supplied with such equipment and /or software. You should contact your
third-party supplier for details.
Declaration of Conformity
Renishaw plc hereby declares that the encoder system is in compliance with the essential
requirements and other relevant provisions of:
• the applicable EU directives
• the relevant statutory instruments under UK law
The full text of the declaration of conformity is available at: www.renishaw.com/productcompliance.
C