Installation 13
Renkforce PL500D WiFi
The LED status display can be deactivated on the configuration interface of
the PL500D WiFi (see 'LED settings').
3.3.2 PLC button
The PLC button controls the following PLC functions:
• Encrypting the PLC network
•To encrypt
your PLC network individually, press each PLC encryption
button on the connected devices for approx. 1 second within 2 min-
utes (see 'Connecting the adapter').
•To remove
a PLC device from your network, press the PLC encryption
button on the corresponding device for at least 10 seconds (see 'Con-
necting the adapter').
• Indicator lights:
The integrated indicator lights (LEDs) show all of the PLC statuses for the
PL500D WiFi by illuminating and/or flashing:
•The LED
flashes slowly. There is no connection to the PLC network.
Check whether the adapter is connected
to the mains supply correctly and
whether the encryption process has been carried out successfully. For more
information, refer to 'Connecting the adapter' and 'Network configuration'.
•The LED lights
green. The network connection is suitable for HD video
streaming.
•The LED lig
hts orange. The network connection is suitable for SD video
streaming and online gaming.
•The LED lights red. The network connection is suit
able for simple data
transfer and Internet access.
The LED status display can be deactivated on the
configuration interface of
the PL500D WiFi (see 'LED settings').
To Next Page
Loading...
Need help?
General
