14 Installation
Renkforce PL500D WiFi
• WiFi Move
WiFi Move is a function for synchronising the Wi-Fi
settings of all
PL500D WiFi adapters connected to your home network.
•Within 2 minutes first press the
PLC button of the existing PL500D WiFi
(approx. 1 second) and finish by pressing the PLC button of the new
PL500D WiFi (approx. 1 second).
•The existing
PL500D WiFi transmits its entire Wi-Fi configuration to the
new PL500D WiFi adapter. The existing and the new PL500D WiFi
ad
apters are now continuously connected with each other, and from
now on exchange changes to the Wi-Fi configuration automatically
with each other.
For more information on the WiFi Move, refer to Chapter 'WiFi Move'
3.3.3 Reset
The Reset button (next to the network jack) has two different functions:
• The
device restarts if you press the Reset button for less than 10 seconds.
• To change the configuration of the PL500D WiFi back to the factory
def
aults, press the Reset button for more than 10 seconds. Keep in mind
that all settings that have already been configured will be lost!
You can use the tip of a drawing pin to press the reset button.
3.3.4 Network connection
Via the LAN port, a computer or another network device can be connected to
the PL500D WiFi via a commercially available network cable.
3.3.5 Wi-Fi antennas
The internal Wi-Fi antennas are for connecting to other network devices wire-
lessly.
3.4 Connecting the adapter
The device is designed for indoor use only.
Note the WiFi key of the PL500D WiFi before the networking procedure. You
will find the unique adapter key on th
e label on the back of the housing.
To Next Page
Loading...
Need help?
General
