18 Installation
Renkforce PL500D WiFi
Integrating additional PL500D WiFi adapters into a WiFi network
Establish the WiFi connection with your laptop, tablet or smartphone by
entering the previously note
d WiFi key as the network security key.
For the PL500D WiFi to show the same WiFi configuration as your WiFi
router, you can apply the WiFi
access data at the touch of a button. The
WiFi Clone function can be enabled in different ways:
Enabling WiFi Clone at the touch of a button
First press the PLC encryption button
on the front side of PL500D WiFi
and then press the WPS button of the WiFi router with the access data
you want to apply.
or
Enabling WiFi Clone via the configuration interface
. For more infor-
mation about this function, refer to Chapter 'WiFi Clone'.
First press the PLC encryption button (for about
1 second) on the existing
WiFi adapter that has the entire WiFi configuration which is to be trans-
ferred to the new PL500D WiFi adapter now, and then press the PLC
encryption
button on the new PL500D WiFi (for about 1 second). The
existin
g WiFi adapter transmits both the PLC as well as the entire WiFi
configuration to the new PL500D WiFi adapter.
To integrate additional PL500D WiFi adapters into your WiFi-ac, repeat
this step.
The WiFi adapters are now continuously connected to
each other and, from
now on, share changes to the WiFi configuration with each other automati-
cally.
To customise your WiFi network security, install
the configuration software
and proceed with configuring your network. To do so, read Chapters 'Instal-
ling the software' and 'Network configuration'.
3.5 Installing the software
To install the software, insert the included CD-ROM in the CD drive of
your computer. The installation wizard will guide you through the software
installation.
To Next Page
Loading...
Need help?
General
