About the manual 5
Renkforce PL500D WiFi
1 About the manual
Carefully read all instructions before setting up the device and store the
manual and/or installation guide for later reference.
After a brief introduction to "PLC" and "WLAN“ basics and the presentation of
the PL500D WiFi
in Chapter 2, Chapter 3 will cover successfully setting up
your adapter and integrate it in your network. Chapter 4 describes configura-
tion options in detail for the built-in configuration interface, including access
to the
Wi-Fi. How you can manage the PL500D WiFi using the PLC configu-
ration software is covered in Chapter 5. Tips for bandwidth
optimization, infor-
mation of environmental compatibility of the device and our warranty
conditions can be found in Chapter 6 and conclude the manual.
1.1 Intended use
Use the adapter as described in these instructions to prevent damage and
injuries.
The device is designed for indoor use only.
1.2 CE conformity
This product complies with the technical requirements of the directive 1999/
5/EC (R&TTE) and the other relevant provisions of the FTEG, and it is desi-
gned for use in the EU, Norway and Switzerland. The product is class A
equipment. Class A
devices may cause interference when used in residential
environments.
"99/05/CE" (R&TTE directive) is a directive similar to the EMC directive. It
applies to radio equipment and telecommunication terminal equip-
ment.Observance of these directives is verified
by the use of harmonized
European norms.
For the CE declaration for this product, refer to the accompanying product
CD
.
To Next Page
Loading...
Need help?
General
