Renkforce RF100 XL - 5 SD Card Contents; A) 3 D Models; B) Config

6
5. SD card contents
• The SD card contains the following folders:
- "3D models"
- "Cong"
- "Manual" (user manual)
- "Software"
To view the contents of the SD card, connect the 3D printer (with the SD card inserted) to your computer.
The control panel on the printer only gives you limited access to the SD card.
a) 3D models
• The "3D models" folder contains several subfolders, including "Basic shape", "Capital letters (A-Z), "Constellation",
"Mathematical symbols", "Numbers (0-9)" and "VariousObjects".
• These subfolders contain over 100 3D models.
• Each model is available in .gcode (.Digicode), .jpg and .stl format. Example: "RF100 ":
• The JPG le allows you to preview the model.
The STL le allows you to create your own GCODE le using the "Cura" software.
Use the GCODE le for printing.
• To start printing, insert the SD card into the slot on the 3D printer, or load the .stl le on your computer using the
"Cura" software.
The printer's control panel only lists the les in .gcode format.
b) Cong
• The "Cong" folder contains conguration les for different lament materials:
- "Copper" (copper)
- "Elastic" (Elastic material)
- "PLA"
- "Wood" (wood)
- "ABS"