Renkforce RF100 XL - Safety Instructions; General Safety Information

9
8. Safety instructions
Read the operating instructions and safety information carefully. If you do not follow the safety
instructions and information on proper handling in this manual, we will assume no liability for any
resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.
a) General information
• For safety reasons, unauthorised conversions and/or modications to the product are not permitted
(other than those indicated in these instructions), as this may damage the components and affect the
functionality/safety of the device.
• All people who use, install, mount or repair this product must be suitably qualied and follow the
instructions.
• The 3D printer is not suitable for people with physical, sensory or mental disabilities or people who are
not suitably qualied.
• This product is not a toy and must be kept out of the reach of children! Children do not understand the
hazards associated with the incorrect use of electrical devices.
• The mechanical components are high-precision parts. Do not use any force, as this may damage the
components and render the 3D printer unusable.
• Never cover the product during use. Only move, transport or store the product when it is switched off.
• Do not leave packaging material lying around carelessly, as it may become dangerous playing material
for children.
• Protect the product against extreme temperatures, direct sunlight, strong jolts, vibrations, ammable
gases, vapours, dust, solvents, high humidity, moisture (e.g. rainwater and steam) and strong mechanical
loads.
• If it is no longer possible to operate the product safely, stop using it and prevent unauthorized use. Safe
operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in adverse ambient conditions or
- has been subjected to any serious transport-related stress.
• Always handle the product carefully. Jolts, impacts or a fall even from a low height may damage the
product.
• Do not cover the ventilation slots on the bottom of the printer. Do not insert sharp objects into the printer,
as this may cause an electric shock.
• Never attempt to disassemble the 3D printer or service any of the interior components.
• Warning, LED light: Do not look directly at the LED light! Do not look into the beam directly or with optical
instruments!
• Observe all additional safety information in the individual sections of these instructions.
• Consult a technician if you are not sure how to use or connect the product.
• Maintenance, modications and repairs must be done by a technician or a specialist repair centre.