47
Connect line 18 to the plug connector of the Y-motor and fasten
the line to the motor with 2 small cable ties (99 mm) that are
combined as shown.
Route line 18 through the opening in the Y-plate upwards as
well.
Apply two large cable ties (142 mm) for tension relief each at
the two drag chain end pieces.
For the lower drag chain end piece at the Y-plate, include the
line to the Y-motor in the tension relief.
Push the lines into the last remaining drag chain (25 links, open
on the outside) so that the end link points to the line ends with
the label with the nipples.
Latch the drag chain in the end piece at the Y-plate.
To Next Page
Loading...
