ResMed AIRMINI User Manual

English 19
Problem/possible cause
Solution
I am using the HumidAirX/HumidAirX Plus and I am getting uncomfortable
droplets of water on my nose, mask or AirMini tube.
Humidity level is too high If using the HumidAirX: Remove the
HumidAirX and try therapy without
humidification.
If using the HumidAirX Plus: Try the
HumidAir X instead. This will help to
reduce the water droplets.
If you are still experiencing problems,
contact your care provider.
Note: You may need to use the
HumidAirX/HumidAirX Plus when ambient
humidity conditions change.
General warnings and cautions
WARNING
• Make sure that you arrange the AirMini tube so that it will not
twist around the head or neck.
• Keep the power cord away from hot surfaces.
• Make sure the power cord and plug are in good condition and
the equipment is not damaged.
• If you notice any unexplained changes in the performance of the
machine, if it is making unusual sounds, if the machine or the
power supply are dropped or mishandled, or if the enclosure is
broken, discontinue use and contact your care provider or your
ResMed Service Center.
• Do not open or modify the machine. There are no user
serviceable parts inside. Repairs and servicing should only be
performed by an authorized ResMed service agent.

ResMed AIRMINI Specifications

General

Type	Travel CPAP machine
Pressure Range	4-20 cm H2O
Noise Level	30 dBA
Bluetooth	Yes
Operating Mode	CPAP, AutoSet
Sound Level	30 dBA
Altitude Adjustment	Automatic
Operating Temperature	41°F to 95°F (5°C to 35°C)
Weight	0.66 lbs
Power Supply	AC 100-240V, 50-60Hz
Humidification	Optional, with HumidX/HumidX Plus waterless humidification
Data Storage	Via AirMini app
Power Consumption	6.3W
Ramp Time	0 to 45 min (5-minute increments)
Compatible Masks	AirFit P10, AirFit N20, AirFit F20
Operating Humidity	10 to 95% relative humidity, non-condensing