ResMed S9 Series Quick Start Guide

Disassembling the H5i Humidifier
1
5
9
2
6
10
3
7
4
8
1
Slide the latch.
2
Lift open the flip lid.
3
Remove the water tub.
4
Discard any excess water from the water tub.
5
Unclip all four side latches.
6
Pull apart the tub lid, plate and base.
7
Remove the maximum water level mark from the plate by pinching and pushing out the locks.
8
Locate the air outlet on the back of your H5i.
9
Remove the outlet clip by pulling apart the clip ends and sliding it off.
10
Remove the air outlet by pushing it through to the inside of the H5i.
S9 VPAP Tx Lab System | Quick Start Guide
Lab Support 24-7 (888) 288-6738
6

ResMed S9 Series Specifications

General

Data Storage	SD card
Device Type	CPAP Machine
Pressure Range	4 to 20 cm H2O
Sound Level	24 dB
Power Supply	100-240V AC, 50/60Hz
Therapy Modes	CPAP, VPAP ST, VPAP Auto
Altitude Adjustment	Yes
Operating Temperature	+41°F to +95°F (+5°C to +35°C)
Operating Humidity	10% to 95% non-condensing
AC Voltage	100-240V AC
Humidifier	optional
Ramp	Yes