Revv Owner’s Manual - 38
Preset Mode
When the footswitch is in preset mode, each button can then be used to
save amp settings, much like a MIDI program change command. For
example, if you wanted to save an amp setting like: ch2, aggression: high,
bright: on, fat: on, FX loop: in, Master volume: 2, you could save this all to
one button! Then every time you want to use this amp configuration, all
you would have to do is press that one button & the amp would change
to this setting. Each button on the foot controller can save settings.
Note: When a preset is set on the foot switch, it will not be lost if power is
removed from the amp. The Revv footswitch has memory & will retain the
settings. Each button is identical in Preset mode & will be considered
banks. Each bank can hold an amp preset.
Note: Buttons one & four however, have 2 functions in preset mode.
Button one will switch between the modes (Control & Preset), & button
four will activate mute in the same way as in control mode. Holding either
button for 2 seconds will activate these abilities.
To save a preset to a bank:
1) Put the footswitch in preset mode & select the bank you want to save
to (Buttons one through four).
2) Set the amplifier to your desired configuration from the front panel of
the amp.
3) The bank LED on the footswitch you have selected will begin to blink
stating a change has been made on the front panel of the amp.
4) Once you’re finished configuring the amp, simply press the desired
bank button on the footswitch to save the setting into that bank & you’re
done! The LED will stop flashing verifying that the change has been
saved. Now every time you press that bank button, the amp will switch to
the configuration you saved to it.
7.3
To Next Page
Loading...
