Revv Owner’s Manual - 6
Front Panel Layout
Input
1/4” Instrument cable input.
Active Input
The active input jack is to be used with guitars that have active pickups
& work better with lower impedance than a guitar with passive pickups.
Because active pickups don’t require high impedance & usually provide
a stronger signal out, this jack provides the proper circuit in order to keep
the tone of the amp articulate & preventing unwanted compression &
noise. If you are finding the tone weak to your personal tastes - do not
hesitate to plug an active pickup-equipped guitar into the passive input
to experiment with new sounds. This operation is safe - & will just hit the
front end of the amp harder if you are going for that sound.
Passive Input
The passive input jack is to be used with guitars that have passive pick-
ups & require high impedance for proper signal transfer. This jack is
designed to get the strongest signal from a passive pickup to the first
tube stage.
2.0
2.1
To Next Page
Loading...
