Getting Started
19
© 2018
REXING All Rights Reserved
Powering the Camera
Connect your camera to your vehicle via the included car charging cable to
power your camera and charge the battery while driving.
Connect the charger to the car cigarette lighter or 12V DC power outlet, then
insert the mini-USB end of the charger into the mini-USB port on the camera.
• You should always connect the camera to a power source while
recording. The internal battery is primarily used to save files in the
event of an emergency, and is only intended to handle a maximum of
15 minutes of disconnected operation.
• If the battery is completely depleted, the device will not turn on
immediately when the charger is connected. Allow a depleted battery
to charge for at least 5 minutes before attempting to turn on the
device.
• If the device receives an unstable power supply while charging, the
screen may not function properly. If this happens, unplug the charger
from the device.
• While charging, the device may heat up. This is normal and should
not affect the device’s performance or lifespan.
• If the device is not charging properly, take the device and the charger
to an authorized Rexing Service Center or contact Customer Care.
Connecting the charger improperly may cause serious damage to the
device. Any damage caused by misuse is not covered by the warranty.
Use only Rexing-approved chargers. Using unapproved chargers or cables
can damage the device or cause the battery to explode.
To Next Page
Loading...
