Getting Started
23
© 2018
REXING All Rights Reserved
Basic Operation
Auto On / Off
The device will automatically power on and start recording from both cameras
once it begins receiving a charge, such as when you start your car.
There will be a red dot blinking on the top left of the screen to indicate that the
camera is currently recording.
Once power is disconnected, the device will shut down after 5 seconds.
Display Control
Tap on the display to bring up the display menu.
Use the slider at the top of the display to adjust display brightness.
To switch between camera views, swipe left or right on the display. The device
will continue to record from both cameras, regardless of the view.
To adjust the rear camera view, swipe up or down on the display.
To toggle the display, briefly press the Power button.
Locking Videos
While recording, you can tap the Lock button to manually lock the current video
clip. This will ensure that the clip will not be overwritten by Segment Recording
when the memory card is full.
Locked videos can be found on the memory card under the “Lock” folder.
To Next Page
Loading...
