Note: The device is configured with a streaming media rearview camera that
provides clear traffic view behind the car. To obtain clearer and more intuitive
images, it is recommended to mount the camera above the license plate (as
shown by option B).
3. Instructions for Reverse Trigger Wiring
The red wire of the car’s reverse gear wiring is connected to the positive end of
one of the car’s reverse light. Make sure that the car charger is energized during
use.
III. Turn on the Dash Cam
Connect the dash cam to the car charger after installation. Starting the car
engine will start the device. The built-in battery will be charged at the same
time.
Note: Due to unstable voltages caused by starting the car engine, a voltage
fluctuation in some vehicles may be especially obvious. If a flashing screen or
some other unforeseeable operating problem occurs when you start the engine,
it is recommended to unplug the device from the charger before starting the
engine, and then reconnect it after the engine is running.
To Next Page
Loading...
