21
© 2015
REXING
A
ll Righ
ts
Re
s
er
v
ed
.
Getting Started
Installing your V1 Dashboard Camera
Charging the battery
Charge the device by connecting the camera via the USB car charger port. Use
only Rexing-approved chargers. Using unapproved chargers or cables can
damage the device or cause the battery to explode.
Connect the car charger’s jack to the USB charging port, and then plug the
charger into the car cigarette lighter or 12V DC power outlet.
Battery is mainly used to save files in emergency. Please always
connect Rexing V1 to external power while it is in use.
When device detects no power supply, it will automatically power off
after 5 seconds. To turn on the device again, you will need to do so
manually by pressing the ON / OFF button.
If the battery is completely discharged, the device will not turn on
immediately when the charger is connected. Allow a depleted battery
to charge for a few minutes before attempting to turn on the device.
The device can be used while it is charging, although it may take
longer to fully charge the battery.
If the device receives an unstable power supply while charging, the
screen may not function properly. If this happens, unplug the charger
from the device.
To Next Page
Loading...
