IKONIC Tankless Water Heater Service Manual
26
GENERAL INFORMATION
1.6.4 TANKLESS
CONFIGURATION
This section is applicable for pump built in models,
and standard models with an external pump following
the pump installation described in this Use and Care
manual. If the external pump is installed independently
from the water heater, this section is not applicable. For
recirculation setting, timer mode, schedule mode, and
on demand mode are available. Timer mode also has
Performance mode and Energy Saver mode. Read next
several pages to set most suitable mode. Contact ser-
vice department if additional help is needed.
1.6.4.1.1 TIMER MODE
1. Press the “ SETTINGS ” button.
2. Press the “ ▼ ” or “ ▲ ” button until “Tankless Con-
fig” is displayed, and press “ENTER” button to con-
firm.
3. The Factory setting is “None”. Press the “▼” or
“▲” button to select “Timer Perf” or “Timer E Sav-
er” and press “ENTER” to confirm. To exit this set-
ting, press BACK " button until the initial screen is
displayed.
RECIRCULATION OPERATION
TIMER MODE
The water heater is turned ON when the recirculation
pump starts operation. The water heater produces hot
water at the setting temperature. When the return wa-
ter temperature reaches approximately 15°F below the
setting temperature, the water heater and the pump will
turn OFF.
The cycle will restart at the approximate time based on
the temperature thermistor readings.
PERFORMANCE MODE (TIMER PERF)
The performance mode operates as below;
• Higher energy consumption due to more pump
cycles.
• Pump cycles ON Every 15 to 30 minutes.
ENERGY SAVER MODE (TIMER E SAVER)
The Energy Saver mode operates as below;
• Less energy consumption due to less pump cycles.
• Pump cycles ON Every 30 to 60 minutes.
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
To Next Page
Loading...
