IKONIC Tankless Water Heater Service Manual
27
GENERAL INFORMATION
1.6.4.1.2 ON DEMAND MODE
1. Press the “ SETTINGS ” button.
2. Press the “▼” or “▲” button until Tankless Config ”
is displayed, and press the “ ENTER ” If incorrect
setting is entered at any steps, press the " BACK "
button until the initial screen. Redo from step 1.
3. Press the “▼” or “▲” button until “Recirc. Pump
Modes” is displayed, and press "ENTER" to con-
firm.
4. The Factory setting is “ None ”. Press the “ ▼ ” or “
▲ ” button until “ On Demand ” is displayed, and
press "ENTER" to confirm. To exit this setting,
press "BACK" button until the initial screen is dis-
played.
RECIRCULATION OPERATION ON
DEMAND
The following accessories are needed to use the On
Demand recirculation activation.
When set to "On Demand" mode, the recirculation
pump is ON for 5 minutes when the signal from the Mo-
tion Sensor or Wired Push Button is received, or until
the return water temperature reaches approximately
15°F below the setting temperature.
For information about On Demand accessories, refer to
"If You Need Service" in the U&C Manual, "Call For As-
sistance" for the telephone number to speak to a Cus-
tomer Service Representative in the U&C manual.
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
On Demand
RHEEM PART
NUMBER
DESCRIPTION
SP20862 Motion Sensor Kit
SP20863 Wired Push Button
To Next Page
Loading...
