Rheem IKONIC RTGH-SR11i - Clearing the Current Alarms

IKONIC Tankless Water Heater Service Manual
34
GENERAL INFORMATION
CLEARING HISTORICAL
ALARMS
1. Redo from above step.2, and press the “▼” or
“▲” button until "Clear History?" is displayed, and
press “ENTER” to confirm.
2. Press the “▼” or “▲” button until "Yes" is dis-
played, and press the “ ENTER ” button. To exit
this setting, press “ BACK ” button until the initial
screen is displayed.
1.7.3 MANIFOLD ROTATE
This tankless water heater can be set to rotate the
"Manager" unit in a manifold system by completing the
following steps:
1. Press the “ SERVICE ” button on the instance 01
heater.
2. Press the “▼” or “▲” button until "Manifold ro-
tate?" is displayed, and press the "ENTER" button.
3. The factory setting is “No”. Press the “▼” or “▲”
button until "Yes" is displayed, and press the “EN-
TER” button. To exit this setting, press “BACK” but-
ton until the initial screen is displayed.
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Clear History
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Current Alarms
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Clear Alarms?
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Yes
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Manifold Rotate