Rheem IKONIC RTGH-SR11i - Recirculation Operation Manually Operate Pump

IKONIC Tankless Water Heater Service Manual
29
GENERAL INFORMATION
2. Press the “ ▼ ” or “ ▲ ” button until "Tankless Con-
fig." is displayed, and press the " ENTER " button.
If incorrect setting is entered at any steps, press
the " BACK " button until the initial screen. Redo
from step 1.
3. Press the “ ▼ ” or “ ▲ ” button until "Recirc . Pump"
is displayed, and, press “ENTER” to confirm.
4. The Factory setting is “Disabled”. Press the “▼”
or “▲” button until "Enable" is displayed and
press the "Enter" button. To exit the setting, press
"BACK" button until the initial screen is displayed.
RECIRCULATION OPERATION
MANUALLY OPERATE PUMP
When set the “Recirc. Pump” ON, the recirculation
pump is ON for 5 minutes or until the return water tem-
perature reaches approximately 15 F below the setting
temperature.
1.6.4.3 HIGH ALTITUDE
ADJUSTMENT
1. Press the “ SETTINGS ” button.
2. Press the “ ▼ ” or “ ▲ ” button until Tankless Con-
fig ” is displayed, and press ENTER ” to confirm.
3. Press the “ ▼ ” or “ ▲ ” button until “Elevation” is
displayed, and press the “ ENTER ” button.
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Enable
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless Config
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Elevation
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SEA LEVEL