Rheem IKONIC RTGH-SR11i - Page 30

IKONIC Tankless Water Heater Service Manual
30
4. The factory setting is “ Sea Level Press the “▼” or
“▲” button to select "Low Altitude", "Med. Alti-
tude" and "High Altitude", and press "ENTER" to
confirm.
1.6.4.4 WATER SAVING CONTROL
1. Press the “ SETTINGS ” button.
2. Press the “▼” or “▲” button until "Tankless Con-
fig." is displayed, and press "ENTER" to confirm.
3. Press the “▼” or “▲” button until "Water Saver
Mode ” is displayed, and press "ENTER" to con-
firm.
4. The Factory setting is "Off" Press the “▼” or “▲”
button to select "On" and press the "ENTER" but-
ton to confirm. To exit this setting, press "Back".
1.6.4.5 SETTING MANIFOLD
HEATERS
This setting is used to tell the “Manager (unit with in-
stance number 1)” in a series of manifold heaters how
many manifold heaters it will be managing. Refer to the
following steps to set this.
1. Press the “SETTINGS” button.
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless Config
SETTINGS
BACK ENTER
STATUS SERVICE MODE
ALTITUDE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Sea Level
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
TANKLESS CONFIG
SETTINGS
BACK ENTER
STATUS SERVICE MODE
On
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Off
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Water Saver Mode
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
TANKLESS CONFIG
SETTINGS
BACK ENTER
STATUS SERVICE MODE
On
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Off
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Water Saver Mode
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
GENERAL INFORMATION
SECTION HIGH-ALTITUDE
Sea Level 0 – 2,000 ft
(0 m – 610 m)
Low Altitude 2,001 ft – 5,400 ft
(610 m – 1,650 m)
Med. Altitude 5401 ft – 7,900 ft
(1,650 m – 2,410 m)
High Altitude 7,901 ft – 10,200 ft
(2,410 m – 3,110 m)