IKONIC Tankless Water Heater Service Manual
79
HOW TO REMOVE COMPONENTS
3.14 CONTROL BOARD BRACKET 3.15 POWER CORD
1. Remove all 9 connectors from the control board.
2. Remove top center screw from control board-
mounting bracket, and 2 screws located on bot-
tom.
3. Pull control board bracket out of way to access
components.
1. Locate YELLOW Molex connector attached to
power cord.
2. Disconnect YELLOW Molex connector and remove
two screws from control board bracket as pictured
below.
3. Pull grommet and cord through bottom of water
heater cabinet.
To Next Page
Loading...
