Rheem IKONIC RTGH-SR11i - Service Menu Functions

IKONIC Tankless Water Heater Service Manual
31
GENERAL INFORMATION
2. Press the “▼” or “▲” button until "Tankless Con-
fig” is displayed, and press "ENTER" to confirm.
3. Press the “▼” or “▲” button until "Manifold heat-
ers” is displayed, and press “ ENTER ” to confirm.
4. The factory setting is "1".
Press the “▼” or “▲” button to select the number
of heaters of be managing " 1 " to "20 ", and press
"ENTER" to confirm. To exit this setting, press
"BACK".
1.6.5 NETWORK INSTANCE
1. Press the “ SETTINGS ” button.
2. Press the “ ▼ ” or “ ▲ ” button until “Network in-
stance” is displayed, and press " ENTER " button
to confirm.
3. The factory setting is " 1 ". Press the “ ▼ ” or “ ▲
” button to select "1" to "20" for each water heater,
and press "ENTER" to confirm. To exit this setting,
press "BACK" button until the initial screen is dis-
played.
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Manifold Heaters
SETTINGS
BACK ENTER
STATUS SERVICE MODE
10
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
120
°F
SETTINGS
BACK ENTER
STATUS SERVICE MODE
120
°F
SETTINGS
BACK ENTER
STATUS SERVICE MODE
115
°F
Press button
to access
“SETTINGS”
Menus
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Network Instance
SETTINGS
BACK ENTER
STATUS SERVICE MODE
10