45
OPERATING INSTRUCTIONS AND SHUTOFF PROCEDURES - DIRECT IGNITION SYSTEMS
1. STOP! Read the safety information above on this
label.
2. Set the thermostat to the lowest settings.
3. Turn off all electric power to the appliance.
4. This appliance does not have a pilot. It is equipped
with an ignition device which automatically lights the
burner. Do not try to light the burner by hand.
5. Remove the heater's top panel.
6. Pull toggle style switch away from you to turn gas
“OFF”.
7. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas
STOP! Follow “B” in the safety information above on
this label. If you don’t smell gas, go to the next step.
8. Push the toggle switch towards you to turn the gas
“ON”.
LIGHTING INSTRUCTIONS
1. Set the thermostat at the lowest setting.
2. Turn o all the electrical power to the appliance if
service is to be performed.
3. Remove the heater's top panel.
TO TURN OFF GAS TO APPLIANCE
4. Pull toggle style switch away from you to turn gas
“OFF”.
5. Replace heater door panel.
9. Replace heater door panel.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the instructions
“To Turn Off Gas To Appliance” and call your service
technician or gas supplier.
Gas
Inlet
Gas Control
Knob Show In “OFF”
Position
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance does not have a pilot. It is equipped
with an ignition controller which automatically
lights the burner. DO NOT try to light the burner
by hand.
B. BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air and
will settle on the floor.\
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the re
department.
C. Use only your hand to turn the gas control ON or OFF.
Never use tools. If you cannot change the ON/OFF
setting by hand, do not try to repair it, call a qualified
service technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
A
WARNING: If you do not follow these instructions
exactly, a re or explosion may result causing property
damage, personal injury or loss of life.
To Next Page
Loading...