Procedure for Sending E-mails
69
6
It is possible to use alphabets,
numbers and periods. The sym-
bols ()\,;:” cannot be used.
For more information to enter
the e-mail address, see the Gen-
eral Settings Guide.
C Press [OK].
The name of the destination ap-
pears in the destination display
area on the upper side of the
screen.
Note
❒ Press [U
UU
UPrev.] or [T
TT
TNext] to
select the destination.
❒ For changing a destination e-
mail address that has been
entered, press [Change] locat-
ed on the left side of the des-
tination list field. A software
keyboard for entering the
destination e-mail address is
displayed. Enter any e-mail
address, and then press [OK].
❒ Pressing the {
{{
{Check Modes}
}}
}
key lets you verify the select-
ed destinations.
D To enter more than one desti-
nation, repeat steps A
AA
A to C
CC
C.
Searching for a destination to
select
A Press [].
The Search/Switch List screen
is displayed.
B Press [Search].
C Press [Search by User Name].
To search using e-mail address-
es, press [Search by E-mail].
D Enter part of the destination
name.
Note
❒ Enter the first character or
characters of the destination
name.
❒ It is also possible to perform
a combined search using
[Search by User Name] and
[Search by E-mail].
E Press [OK].
A list of destinations is dis-
played according to the user
name search.
F Select a destination.
G Press [Exit].
H Press [OK].
The destination name is dis-
played in the destination field at
the top of the screen.
To Next Page