Placing Originals
14
1
A Press [Special Original].
B Press [Mixed Size], and then press
[OK].
C Align the rear and left edges of
the originals as shown.
1. Place into the ADF
2. Vertical size
D Adjust the guide to the widest
original size.
E Place the aligned originals face
up into the ADF.
F Press the {Start} key.
Placing custom size originals
When placing custom size originals in
the ADF, specify the size of the origi-
nals.
Note
r Paper that has a vertical length of
128–297 mm (5"–11") and a hori-
zontal length of 128–1,260 mm (5"–
49") can be placed with this func-
tion.
A Press [Special Original].
B Press [Custm Size Origi.].
C Enter the horizontal size of the
original with the number keys,
and then press [#].
Note
r If you make a mistake, press
[Clear] or the {Clear/Stop} key,
and then enter the value again.
D Enter the vertical size of the origi-
nal with the number keys, and
then press [#].
E Press [OK].
CP19AE
To Next Page
Loading...
