Copier Functions
29
2
B Press [Specifd. Ratio].
C Make sure that [Specifd. Ratio] is
highlighted.
D Enter the length of the original
with the number keys, and then
press the [#] key.
Note
r You can enter sizes within the
following ranges:
E Enter the length of the copy with
the number keys, and then press
[#].
Note
r To change the length after
pressing [#], select [Original] or
[Copy] and enter the desired
length.
F Press [OK].
G Press [OK].
H Place your originals, and then
press the {Start} key.
Directional Magnification (%)
Copies can be reduced or enlarged at
different reproduction ratios, hori-
zontally and vertically.
1. Horizontal ratio
2. Vertical ratio
Note
r You can also select a preset ratio
close to the desired ratio using [Re-
duce] or [Enlarge], then adjust with
[n] or [o].
A Press [Reduce/Enlarge].
B Press [Specifd. Ratio].
C Press [Direct. Mag.%].
To enter the ratio with the number
keys
A Press [Horizontal].
B Enter the desired ratio with the
number keys, followed by [#].
Metric
ver-
sion
1–999 mm (in increments of
1 mm)
Inch
ver-
sion
0.1"–99.9" (in increments of
0.1")
CP2P01EE
To Next Page
Loading...
