15
2. Copying
Basic Procedure
A If the machine has user codes set,
enter a user code (up to eight dig-
its) using the number keys, and
then press the {#} key.
The machine is ready to copy.
Reference
For users codes, see “Key Oper-
ator Tools”, General Settings
Guide.
B Make sure "d Ready" appears on
the display.
If any other function is displayed,
press the {Copy} key.
v Initial copy display
C Make sure no previous settings
remain.
Note
r When there are previous set-
tings remaining, press the {Re-
set} key and enter again.
D Place your originals.
Reference
p.10 “Placing Originals”
E Set your desired settings.
Reference
Please refer to each function.
F Enter the required number of cop-
ies using the number keys.
Note
r The maximum copy quantity
that can be set is 999.
G Press the {Start} key.
Copying begins.
Note
r When placing originals on the
exposure glass, press the {#}
key after all originals are
scanned.
r Copies are delivered face down.
-How to operate
v To stop the machine during a multi-
copy run.
Press the {Clear/Stop} key.
v To return the machine to the initial
condition after copying.
Press the {Clear Modes} key.
v When clearing entered values.
Press the {Clear/Stop} key or [Clear]
on the display.
v To check the settings.
Press the {Check Modes} key.
To Next Page
Loading...
