Specifying the Administrator/Security Functions
112
6
❖ Settings by SNMP V1 and V2
This can be specified by the network administrator. When the machine is ac-
cessed using the SNMPv1, v2 protocol, authentication cannot be performed,
allowing machine administrator settings such as the paper setting to be
changed. If you select [Prohibit], the setting can be viewed but not specified
with SNMPv1, v2.
•Prohibit
• Do not Prohibit
Note
❒ Default: Do not Prohibit
❖ Restrict Use of Simple Encryption
This can be specified by the network administrator.
For example, this setting is set to [On] and you want to edit the address book
in User Management Tool or Address Management Tool in SmartDevice-
Monitor for Admin, or you want to access the machine using DeskTopBinder
or the ScanRouter delivery software, enable SSL/TLS for encrypted commu-
nication. For details about specifying SSL/TLS, see p.59 “Setting the SSL /
TLS Encryption Mode”.
•On
•Off
Note
❒ Default: Off
❖ Transfer to Fax Receiver
This can be specified by the machine administrator.
If you use [Forwarding] or [Forwarding] under the fax function, files stored in the
machine can be transferred or delivered.
If you select [Prohibit] for this setting, stored files cannot be transferred by [For-
warding] and [Transfer Request].
Use this setting, to prevent the stored files being transferred by mistake.
•Prohibit
• Do not Prohibit
Note
❒ Default: Do not Prohibit
❒ If you select [Prohibit] for this setting, the following functions are disabled:
• Polling Transmission
•Transfer Request
•Forwarding
•Transfer Box
• Delivery from Personal Box
•Information Box
• Delivery of Mail Received via SMTP
To Next Page
Loading...
