When the Machine Does Not Operate As Wanted
4
1
Panel Tone
The following table explains the various beep patterns that the machine produces
to alert users about originals left on the machine and other machine conditions.
Note
❒ Users cannot mute the machine's beep alerts. When the machine beeps to alert
users of a paper jam or toner request, if the machine's covers are opened and
closed repeatedly within a short space of time, the beep alert might continue,
even after normal status has resumed.
Reference
For details about enabling or disabling beep alerts, see “General Features”,
General Settings Guide.
Beep pattern Meaning Cause
Two long beeps. Machine has warmed
up.
After cooling or being switched on, the
machine has fully warmed up and is
ready for use.
Single short beep. A valid operation is
accepted.
A control panel or screen key was
pressed, the machine was switched on,
or a document was set on the ADF or
ARDF.
Single long beep. Job completed. A Copier Features job has finished.
Five long beeps repeated
four times.
Soft alert. An original has been left on the expo-
sure glass or paper has run out.
Five short beeps repeated
five times.
Strong alert. Machine requires user attention. Paper
might have jammed or toner might need
replenishing.
To Next Page
Loading...
