Changing the Paper Size
81
6
G Press the {User Tools/Counter} key.
H Load the paper, and then gently push the paper tray in until it stops.
I Check the paper size on the display panel.
Note
❒ For details about the type of paper that can be loaded in Paper Tray 1, see
“Tray Paper Settings”, General Settings Guide.
Changing a Paper Size in the Optional Paper Tray Unit
This section describes how to change the size of paper loaded in the optional pa-
per tray unit.
Important
❒ Do not stack paper over the limit mark.
❒ When setting small quantities of copy paper, be careful not to squeeze in the
side fence too much. Paper might not feed in properly if the side fences are
too tight against the paper's edges.
A Make sure the paper tray is not in use.
B Pull the paper tray out slowly until it stops.
C Remove any remaining copy paper.
D While pinching the release lever, adjust the end fence.
ASB018S
ASB012S
To Next Page
Loading...
