Sending Scan Files by Scan to Folder
60
2
D Enter the path to the destination folder, and then press the {OK} key.
The following is an example of a path where the folder name is “user” and the
computer name is “desk01”: \\desk01\user.
Instead of specifying the destination using its computer name, you can also
use its IPv4 address.
E Enter a user name used to log on to the client computer, and then press the
{OK} key.
F Enter the password used to log on to the client computer, and then press the
{OK} key.
The Confirm Destination screen appears.
G Press [Com.Test].
A connection test starts.
H The test result appears. Press [Exit].
To Next Page
Loading...
