Copying
96
2
E Set an erase border width with [n] or [o].
Pressing [n] or [o ] changes the width in increments of 1 mm (0.1 inch).
Pressing and holding down the relevant key changes the width in increments
of 10 mm (1 inch).
If you select to erase the image on the back of the original, press [2 Sided Set-
ting] and [Back].
Erasing the image on the back is valid when you copy 2-Sided originals.
F Press [OK] twice.
G Place the originals, and then press the {Start} key.
Note
❒ To change the value entered in step
E
, press [n] and [o] to set a new value.
Border Erase (different width)
This mode erases the edge margin of the original image.
A Press [Edit / Stamp].
B Press [Erase].
C Press [Erase Center / Border].
D Press [Different Width].
To Next Page
Loading...
Need help?
General
