Problem Cause Solution
Printing does not start when
using the extended wireless
LAN in Ad-hoc mode.
The correct Communication
mode is not set.
• Turn the main power off and back
on. See “Turning On/Off the
Power”, About This Machine.
• In [System Settings], under
[Interface Settings], select
[Wireless LAN], and then set
[Communication Mode] to
[802.11 Ad-hoc Mode] and
[Security Method] to [Off]. Then at
the other side, set [SSID Setting]
and [Ad-hoc Channel] to the same
values.
The status indicator of the
printer is lit.
The cause is displayed
on the display of the control
panel.
Check the error message on the display
panel and take required action. See
p.39 "Messages Displayed When Using
the Printer Function".
"Updating the destination
list... Please wait. Specified
destination(s) or sender's
name has been cleared."
appears.
The destination list is being
updated from the network
using SmartDeviceMonitor
for Admin.
Wait until the message disappears. Do
not switch off the main power while this
message is displayed. Depending on the
number of destinations to be updated,
there may be some delay before you
can resume operation. Operations are
not possible while this message is
displayed.
If the printing does not start, consult your service representative.
When the Data In Indicator Does Not Light Up or Flash
When the Data In indicator does not light up or flash after starting a print job, data is not being sent to the
machine.
When the machine is connected to the computer using the interface cable
This section describes how to check the print port when the Data In indicator does not light up or blink.
Check if the print port setting is correct. When it is connected using a parallel interface, connect it to LPT1
or LPT2.
When You Cannot Print
51
To Next Page
Loading...
