Problem Cause Solution
You want to check print
quality before making a large
print run.
You can print a single copy
without specifying the setting
again.
Check print quality by printing out only
the first set using the [Sample Copy] key.
See “Finishing”, Copy/Document
Server Reference.
"Cannot display preview of
this page." appears, and you
can not check the thumbnail
image.
The image data may have
been corrupted.
Press [Exit] to display the preview screen
without a thumbnail.
If the selected document contains
several pages, press [Switch] on the
“Display Page” area to change the
page, and then a preview of the next
page will appear.
When Memory Is Full
This section describes likely causes of and possible solutions for problems related to full memory.
Message Cause Solution
"Memory is full. nn originals
have been scanned. Press
[Print] to copy scanned
originals. Do not remove
remaining originals."
“n” in the message represents
a changeable number.
The scanned originals
exceeds the number of
pages that can be stored in
memory.
Press [Print] to copy scanned originals
and cancel the scanning data. Press
[Stop] to cancel the scanning data and
not copy.
"Press [Continue] to scan and
copy remaining originals."
The machine checked if the
remaining originals should be
copied, after the scanned
originals were printed.
To continue copying, remove all copies,
and then press [Continue]. To stop
copying, press [Stop].
2. Troubleshooting When Using the Copy/Document Server Function
34
To Next Page
Loading...
