5. Adding Paper and Toner
This chapter describes troubleshooting procedures that are applicable to all the machine's functions.
Loading Paper
This section describes what to do when paper runs out and needs reloading.
• Be careful when replacing the roll paper or removing misfed paper by following the operating
instructions properly. Otherwise, an injury may result from the paper cutter inside.
• When replacing or loading the paper roll, do not put the paper roll on the upper of the paper roll
tray. Otherwise the tray may fall and an injury may result.
• Hold the paper rolls horizontally with both hands. When you grab the paper holder and hold the
paper roll vertically, the paper roll may fall off and an injury may result.
• When loading paper, take care not to trap or injure your fingers.
• When removing paper rolls, lift the paper holders on either side of the paper roll before removing.
Do not lift one side only. This could damage the machine.
• If the original hanger (optional) is installed, remove it before pulling out the paper roll tray or cut
paper tray.
• For paper types and sizes that can be loaded in the paper roll tray and cut paper tray, see
“Recommended Paper Sizes and Types”, About This Machine.
• For details about changing the paper size in the paper roll tray or cut paper tray, see “Changing the
Paper Size”.
• To load paper in the bypass tray, see “Copying from the Bypass Tray”, Copy/Document Server
Reference.
77
To Next Page
Loading...
