Ricoh Aficio MP W7140 - Page 221

Setting Description Setting Value
Address Type
Specify the address type for
which IPsec transmission is
used.
• Inactive
• IPv4
• IPv6
• IPv4/IPv6 (Default
Settings only)
Local Address
Specify the machine's address.
If you are using multiple
addresses in IPv6, you can also
specify an address range.
The machine's IPv4 or IPv6
address.
If you are not setting an address
range, enter 32 after an IPv4
address, or enter 128 after an
IPv6 address.
Remote Address
Specify the address of the IPsec
transmission partner. You can
also specify an address range.
The IPsec transmission partner's
IPv4 or IPv6 address.
If you are not setting an address
range, enter 32 after an IPv4
address, or enter 128 after an
IPv6 address.
Security Policy Specify how IPsec is handled.
• Apply
• Bypass
• Discard
Encapsulation Mode
Specify the encapsulation
mode.
(auto setting)
• Transport
• Tunnel
(Tunnel beginning address -
Tunnel ending address)
If you specify “Tunnel”, you
must then specify the “Tunnel
End Points”, which are the
beginning and ending IP
addresses. Set the same
address for the beginning point
as you set in “Local Address”.
Transmission Using IPsec
219
5