5. Enter a login password, and then press [OK].
If a login password has not been specified, press [OK] without entering the password.
The message, "Authenticating... Please wait." appears.
Logging off as the Supervisor
If administrator authentication has been specified, be sure to log off after completing settings. This section
describes how to log off after completing settings.
1. Press the [Login/Logout] key.
2. Press [Yes].
"Logging out... Please Wait." appears.
Changing the Supervisor
This section describes how to change the supervisor's login name and password. To do this, you must to
enable the user administrator's privileges through the settings under [Administrator Authentication
Management]. For details, see “Specifying Administrator Privileges”.
For details about logging on and logging off as the supervisor, see “Supervisor Operations”.
Supervisor Operations
275
To Next Page
Loading...
