Ricoh Aficio SP 320 Series - Installing the Driver and Software; Quick Install for USB; Quick Install for Network

Installing the Driver and Software
You can install the necessary driver for this machine using the included CD-ROM.
The supplied drivers are supported by the following operating systems:
•
PCL 6 printer driver: Windows XP/Vista/7/8 and Windows Server 2003/ 2003
R2/2008/2008 R2/2012
• TWAIN driver: Windows XP/Vista/7/8 and Windows Server 2003/ 2003 R2/2008/2008
R2/2012
• WIA driver: Windows XP/Vista/7/8 and Windows Server 2003/ 2003 R2/2008/2008
R2/2012
• LAN-Fax driver: Windows XP/Vista/7/8 and Windows Server 2003/ 2003 R2/2008/2008
R2/2012
The procedure in this section is an example based on Windows 7. The actual procedure may vary
depending on the operating system you are using.
• Be sure to disconnect the USB cable or Ethernet cable from the machine and turn the machine off
before beginning the installation.
Quick Install for USB
Use Quick Install to install the printer driver, TWAIN driver, WIA driver, and LAN-Fax driver from the
CD-ROM.
1. Close all applications except this manual.
2. Insert the CD-ROM into the CD-ROM drive.
3. Select a language for the interface, and then click [OK].
4. From the CD-ROM menu, click [USB Quick Install].
5. Follow the instructions in the installation wizard.
Quick Install for Network
Use Quick Install to install the printer driver, TWAIN driver, WIA driver, and LAN-Fax driver from the
CD-ROM.
1. Close all applications except this manual.
2. Insert the CD-ROM into the CD-ROM drive.
3. Select a language for the interface, and then click [OK].
1. Guide to the Machine
28