Specifying the Scan Settings
This section describes how to specify image density and scan quality for the current job.
Adjusting Image Density
There are five image density levels. The higher the density level, the darker the printout.
1. Press the [Density] key.
2. Press the [ ] or [ ] key to select the desired density level, and then press the [OK] key.
• Press the [Escape] key to discard the current change and return to the initial screen.
•
You can change the machine's default [Density] setting to always make copies with a specific
density level. For details, see page 138 "Scanner Features Settings".
• Temporary job settings are cleared in the following cases:
• When no input is received for the period of time specified in [System Auto Reset Timer] while
the initial screen is displayed. For details, see page 166 "Administrator Settings".
• When the [Clear/Stop] key is pressed while the initial screen is displayed.
• When the machine's mode is changed.
• When the power is turned off.
• When the machine's default for the same setting is changed.
Selecting the Document Type According to Original
There are three document types:
Mixed
Select this when the original contains both text and photographs or pictures.
4. Copying Originals
78
To Next Page
Loading...
