Using PostScript 3
Use the PostScript 3 driver to print files.
You can use the following functions in the [Print] dialog:
Paper Size
Use this function to select the paper size.
Input Tray
Use this function to select the tray from which you want to feed paper.
You can select [Auto Select], [Tray 1], [Tray 2], or [Bypass Tray].
Paper Type
Use this function to select the paper type.
In the [Feature Sets] list, select [Paper Type], and then, in the [Media Type] list, select the paper
type you want to use for printing.
Duplex
Use this function to print on both sides of sheets. In the drop-down menu, select [Layout], and then
specify the binding pattern in the [Two-Sided] area. Both short edge and long edge binding is
possible with this function.
Print Quality
Use this function to select the print quality.
In the [Feature Sets] list, select [Imaging], and then, in the [Print Quality] list, select the print quality.
You can select [600 × 600 dpi] or [1200 × 1200 dpi].
Dithering
Use this function to specify the rendering mode.
In the [Feature Sets] list, select [Dithering], and then, in the [Dithering] list, select the rendering
mode.
You can select [Automatic], [Photographic], or [Text].
Toner Saving
Use this function to reduce the amount of toner used when printing.
To reduce toner consumption, in the [Feature Sets] list, select [Toner]. Then set [Toner Saving] to
[On].
Gradation
Use this function to adjust the quality of the output.
You can select [1 bit] or [2 bits].
Using PostScript 3
113
To Next Page
Loading...
